Cleaning Pre-filming Agent Operation Procedure And Subsequent Effect Observation Instructions

The operation procedure for using the cleaning pre-filming agent is crucial, as it directly affects the cleaning and protection effectiveness of the equipment. The following are the detailed operation steps:

Step 1: Preparation. Determine the appropriate dosage of the cleaning pre-filming agent based on the equipment condition and prepare the necessary tools, such as a stirrer and measuring containers.

Step 2: Equipment Cleaning. Initially clean impurities and dirt from the equipment to prepare for subsequent pre-filming.

Step 3: Solution Preparation. Mix the cleaning pre-filming agent with water according to the specified ratio, using a stirrer to ensure the solution is homogeneous.

Step 4: Circulation Cleaning. Inject the prepared solution into the equipment system and start the circulation pump to circulate the solution within the system. The cleaning time depends on the actual situation.

Step 5: Solution Drainage. After cleaning, drain the solution completely and rinse the equipment with clean water.

Step 6: Pre-filming Treatment. Re-pre-compile the pre-filming solution and inject it into the system to perform the pre-filming operation. After pre-filming is completed, drain the solution and rinse the equipment again. The final product exhibits a protective film on the equipment surface, effectively preventing dirt adhesion and equipment corrosion, and extending the equipment's service life.